MTN PRO Acrylic Varnish


MTN PRO Acrylic Varnish is fast drying, thermoplastic acrylic resin-based varnish.Available in glossy, satin finish and matte.



MTN PRO Acrylic Varnish is made with solvent-based thermoplastic acrylic resins. Ultra-fast drying, its main function is to protect and protect different surfaces.

It can be applied for indoor and outdoor use on a multitude of materials in order to increase surface protection in three finishes: glossy, satin or matte.

Different finishes will be obtained depending on the number of layers applied. Completely transparent and does not yellow.

Acrylic varnish could be applied to many materials to protect them and at the same
time to enhance their brightness. Different finishes are obtained depending
on the number of coats applied.
– Wood – Painted materials – Serval plastics
– Wicker – Cork – In general, all surfaces
– Steel – Stone that can be varnished


  • Very fast drying
  • Good hardness
  • Excellent adhesion
  • Good elasticity
  • High durability
  • Easy to apply and recoat
  • Good water resistant
  • Non-yellowing
  • Good resistance to UV light

– Before using, shake the aerosol vigorously for approximately one minute.
– Apply over clean and dry surfaces. On rusty metallic surfaces: Remove
corrosion with a wire brush. In plastics like PS and PP apply first a primer layer.
See product’s behavior in any plastic surface.
– Apply thin coats for better results, better three thin layers than a thick one.
It is recoatable after ten minutes.
– Hold the aerosol upside down after use to purge the valve. If the nozzle
is blocked, replace it with a new one.
– Do not apply on plugged-in electrical equipment and use in well-ventilated areas.
– When applied over other paints do a preliminary test first, as sometimes
the varnish can remove paint on the surface to be varnished.
– Ask for MSDS.

PHYSICAL PROPERTIES Binder: Thermoplastic acrylic Color: Transparent Shine 60º (ASTM D-523 ISO 2813): >80% glossy; 15-35 Satin; <10 Matt Dry touch (ASTM D-1640 ISO 1517): 10’ Cured (ASTM D-1640 ISO 1517): 12 h Dry film thickness (ASTM D-823 ISO 2808): 15 µ/layer (2 coats) Adhesion (ASTM D-3359 ISO 2409): 4 B Theorical yiels (continuous painting): 2 m² Solvent: Butyl acetate Product life: >5 Years Recoating: After 10’ Heat resistance: 150ºC Application conditions: Tº min 8ºC Surface temperature 5ºC a 50ºC Max humidity 85% R.H.P